• Damper system consists of the Electro-Balance™ EB-UDD universal damper drive, MAT EB-200 rectangular damper (or damper by others), a plenum rated wire/connector bundle, and EB-SP8 eight connector interface
• Damper is adjusted using EB-RC battery powered hand held remote (only one required per job)  
• Typical application of the EB-SP8 interface is for multiple branch duct or take-off balancing dampers with central location for the connector termination points
• EB-UDD damper drive is assembled to the MAT EB-200 damper (and tested) prior to shipment
• The EB-SP8 single connector surface termination resembles a standard outlet box cover

• 16 gage galvanized channel frame with braced corners and side plate for mounting EB-UDD damper drive**
• 16 gage galvanized steel blades - opposed blade design (parallel blade optional)

• Self-lubricated synthetic bearings 

** Dampers 12" high and under - 20 gage single blade design and 20 gage straight frame

• A one piece unit consisting of the worm gear drive and damper actuator pre-wired with plenum rated wire/connector bundle 
• Pre-assembled to damper prior to shipment
• 15 second open/close timing provides adequate damper position resolution
• Operated with EB-RC battery powered hand held remote

• UL 94-V0 flammability rated white nylon connector housing and removable cover plate
• Connectors snap in from the rear of the unit
• Numbered connector ports with labeling available on rear side of the cover plate
• Supplied with standard low voltage mounting plate or outlet box