• Damper system consists of the Electro-Balance™ EB-UDD universal damper drive, MAT EB-200 rectangular damper (or damper by others), a plenum rated wire/connector bundle, and EB-SP1 single connector interface
• Damper is adjusted using EB-RC battery powered hand held remote (only one required per job)  
• Typical application is for branch duct balancing, or take-off balancing where the point of damper adjustment is to be in proximity to the air outlet.
• EB-UDD damper drive is assembled to the MAT EB-200 damper (and tested) prior to shipment
• The EB-SP1 single connector surface termination is designed to be an aesthetic alternative to and "inside the air stream" approach

• 16 gage galvanized channel frame with braced corners and side plate for mounting EB-UDD damper drive**
• 16 gage galvanized steel blades - opposed blade design (parallel blade optional)
• Self-lubricated synthetic bearings 

** Dampers 12" high and under - 20 gage single blade design and 20 gage straight frame

• A one piece unit consisting of the worm gear drive and damper actuator pre-wired with plenum rated wire/connector bundle 
• Pre-assembled to damper prior to shipment
• 15 second open/close timing provides adequate damper position resolution
• Operated with EB-RC battery powered hand held remote

• UL 94-V0 flammability rated white nylon material
• Two piece unit installed manually
• 1 3/8" diameter surface plate mounts flush to the ceiling
• Connector access through a removable plug in the surface plate