+1.708.552.4012

Round damper + Electro Balance Universal damper drive + 8 Connector Interface Damper System Features & Typical Application Damper system consists of the Electro-Balance™ EB-UDD universal damper drive, MAT EB-250 rectangular damper (or damper by others), a plenum rated wire/connector bundle, and EB-SP8 eight connector interface Damper is adjusted using EB-RC battery powered hand held remote (only one required per job).   Typical application of the EB-SP8 interface is for multiple branch duct or take-off balancing dampers with central location for the connector termination points EB-UDD damper drive is assembled to the MAT EB-250 damper (and tested) prior to shipment. The EB-SP8 single connector surface termination resembles a standard outlet box cover Round Damper (EB-250) Available in 6 to 20 Ø Single blade shaft driven damper 20 ga. galvanized steel construction EB-UDD drive mounted to damper prior to shipment Open/close blade stops   Electro-Balance™ Universal Damper Drive (EB-UDD) A one piece unit consisting of the worm gear drive and damper actuator pre-wired with plenum rated wire/connector bundle  Pre-assembled to damper prior to shipment 15 second open/close timing provides adequate damper position resolution  Operated with EB-RC battery powered hand held remote  Eight Connector Finished Surface Interface UL 94-V0 flammability rated white nylon connector housing and removable cover plate Connectors snap in from the rear of the unit Numbered connector ports with labeling available on rear side of the cover plate. Supplied with standard low voltage mounting plate or outlet box

AboutProductsWhy Choose MATSales RepsContactHome
+ 1.708.552.4012   800.585.7686    © 2010 Metropolitan Air Technology, A Steelhead Corp Company.All rights reserved.